VulniPulse uses Google Ads measurement to understand visits from advertisements and campaign performance. It runs cookie-free until you choose — accepting enables cookies for more accurate attribution. Rejecting keeps it cookie-free and never limits the site.
See exactly what is measuredComplete feed
Critical/high still unreviewed, or CISA KEV listed
A Use After Free vulnerability was identified in the 802.1X authentication daemon (dot1xd) of Juniper Networks Junos OS and Junos OS Evolved that could allow an authenticated, network-adjacent attacker flapping a port to crash the dot1xd process, leading to a Denial of Service (DoS), or potentially execute arbitrary code within the context of the process running as root. The issue is specific to the processing of a change in authorization (CoA) when a port bounce occurs. A pointer is freed but was then referenced later in the same code path. Successful exploitation is outside the attacker's direct control due to the specific timing of the two events required to execute the vulnerable code path. This issue affects systems with 802.1X authentication port-based network access control (PNAC) enabled. This issue affects: Junos OS: * from 23.2R2-S1 before 23.2R2-S5, * from 23.4R2 before 23.4R2-S6, * from 24.2 before 24.2R2-S3, * from 24.4 before 24.4R2-S1, * from 25.2 before 25.2R1-S2, 25.2R2; Junos OS Evolved: * from 23.2R2-S1 before 23.2R2-S5-EVO, * from 23.4R2 before 23.4R2-S6-EVO, * from 24.2 before 24.2R2-S3-EVO, * from 24.4 before 24.4R2-S1-EVO, * from 25.2 before 25.2R1-S2-EVO, 25.2R2-EVO.
An Improper Handling of Exceptional Conditions vulnerability in the packet forwarding engine (PFE) of Juniper Networks Junos OS on SRX Series allows an unauthenticated network-based attacker sending a specific ICMP packet through a GRE tunnel to cause the PFE to crash and restart. When PowerMode IPsec (PMI) and GRE performance acceleration are enabled and the device receives a specific ICMP packet, a crash occurs in the SRX PFE, resulting in traffic loss. PMI is enabled by default, and GRE performance acceleration can be enabled by running the configuration command shown below. PMI is a mode of operation that provides IPsec performance improvements using Vector Packet Processing. Note that PMI with GRE performance acceleration is only supported on specific SRX platforms. This issue affects Junos OS on the SRX Series: * all versions before 21.4R3-S12, * from 22.4 before 22.4R3-S8, * from 23.2 before 23.2R2-S5, * from 23.4 before 23.4R2-S5, * from 24.2 before 24.2R2-S3, * from 24.4 before 24.4R2-S1, * from 25.2 before 25.2R1-S1, 25.2R2.
A Loop with Unreachable Exit Condition ('Infinite Loop') vulnerability in the SIP application layer gateway (ALG) of Juniper Networks Junos OS on SRX Series and MX Series with MX-SPC3 or MS-MPC allows an unauthenticated network-based attacker sending specific SIP messages over TCP to crash the flow management process, leading to a Denial of Service (DoS). On SRX Series, and MX Series with MX-SPC3 or MS-MPC service cards, receipt of multiple SIP messages causes the SIP headers to be parsed incorrectly, eventually causing a continuous loop and leading to a watchdog timer expiration, crashing the flowd process on SRX Series and MX Series with MX-SPC3, or mspmand process on MX Series with MS-MPC. This issue only occurs over TCP. SIP messages sent over UDP cannot trigger this issue. This issue affects Junos OS on SRX Series and MX Series with MX-SPC3 and MS-MPC: * all versions before 21.2R3-S10, * from 21.4 before 21.4R3-S12, * from 22.4 before 22.4R3-S8, * from 23.2 before 23.2R2-S5, * from 23.4 before 23.4R2-S6, * from 24.2 before 24.2R2-S3, * from 24.4 before 24.4R2-S1, * from 25.2 before 25.2R1-S1, 25.2R2.
A Buffer Over-read vulnerability in the routing protocol daemon (rpd) of Juniper Networks Junos OS and Junos OS Evolved allows an unauthenticated, network-based attacker to cause a Denial-of-Service (DoS). When an affected device receives a BGP update with a set of specific optional transitive attributes over an established peering session, rpd will crash and restart when attempting to advertise the received information to another peer. This issue can only happen if one or both of the BGP peers of the receiving session are non-4-byte-AS capable as determined from the advertised capabilities during BGP session establishment. Junos OS and Junos OS Evolved default behavior is 4-byte-AS capable unless this has been specifically disabled by configuring: [ protocols bgp ... disable-4byte-as ] Established BGP sessions can be checked by executing: show bgp neighbor <IP address> | match "4 byte AS" This issue affects: Junos OS: * all versions before 22.4R3-S8, * 23.2 versions before 23.2R2-S5, * 23.4 versions before 23.4R2-S6, * 24.2 versions before 24.2R2-S2, * 24.4 versions before 24.4R2; Junos OS Evolved: * all versions before 22.4R3-S8-EVO, * 23.2 versions before 23.2R2-S5-EVO, * 23.4 versions before 23.4R2-S6-EVO, * 24.2 versions before 24.2R2-S2-EVO, * 24.4 versions before 24.4R2-EVO.
An Improper Check for Unusual or Exceptional Conditions vulnerability in the Juniper DHCP service (jdhcpd) of Juniper Networks Junos OS and Junos OS Evolved allows a DHCP client in one subnet to exhaust the address pools of other subnets, leading to a Denial of Service (DoS) on the downstream DHCP server. By default, the DHCP relay agent inserts its own Option 82 information when forwarding client requests, optionally replacing any Option 82 information provided by the client. When a specific DHCP DISCOVER is received in 'forward-only' mode with Option 82, the device should drop the message unless 'trust-option82' is configured. Instead, the DHCP relay forwards these packets to the DHCP server unmodified, which uses up addresses in the DHCP server's address pool, ultimately leading to address pool exhaustion. This issue affects Junos OS: * all versions before 21.2R3-S10, * from 21.4 before 21.4R3-S12, * all versions of 22.2, * from 22.4 before 22.4R3-S8, * from 23.2 before 23.2R2-S5, * from 23.4 before 23.4R2-S6, * from 24.2 before 24.2R2-S2, * from 24.4 before 24.4R2, * from 25.2 before 25.2R1-S1, 25.2R2. Junos OS Evolved: * all versions before 21.4R3-S12-EVO, * all versions of 22.2-EVO, * from 22.4 before 22.4R3-S8-EVO, * from 23.2 before 23.2R2-S5-EVO, * from 23.4 before 23.4R2-S6-EVO, * from 24.2 before 24.2R2-S2-EVO, * from 24.4 before 24.4R2-EVO, * from 25.2 before 25.2R1-S1-EVO, 25.2R2-EVO.